User Manual
Table Of Contents
- Chapter 1 System Requirement
- Chapter 2 Network Connection
- Chapter 3 Login
- Chapter 4 Live View
- Chapter 5 Picture Search
- Chapter 6 Log Search
- Chapter 7 Local Configuration
- Chapter 8 System Configuration
- Chapter 9 Encoding and Storage Configuration
- Chapter 10 Text Overlay Configuration
- Chapter 11 Capture Parameters Configuration
- Chapter 12 Image Parameters Configuration
- Chapter 13 Entrances and Exits Configuration
- Chapter 14 Application Mode Configuration
- Chapter 15 Exception
- Chapter 16 Maintenance
- Appendix
Network Traffic Camera User Manual
58
Chapter 14 Application Mode
Configuration
Purpose:
This chapter introduces the parameters configuration under different trigger mode.
The supported trigger modes vary according to the camera models.
Note:
The trigger modes below are for reference only. The trigger modes of the actual
device prevail.
14.1 Smart Mode
In this mode, target capture and license plate recognition are trigger by internal live
video analysis.
Steps:
1. Go to Configuration > Device Configuration > Application Mode.
2. Select Application Mode as Smart Mode.
3. Select Total Lanes. Up to 3 lanes are supported.
Figure 14-1 Smart Mode Configuration