User's Manual

3.3.2 Set RS-485 Communicaon Mode
Steps
1. Set the DIP switch of No. 6 as 0.
2. Set the DIP switch of No. 1 ~ 5 for RS-485 address and reading card mode. For details, refers to
DIP Switch
Descripon .
3. Wire the cable between controller and card reader as shown below.
Figure 3-2 Wiring for RS-485
Communicaon Mode
3.3.3 Set Wiegand
Communicaon Mode
Steps
1. Set the DIP switch of No. 6 as 1.
Card Reader User Manual
7