User's Manual

Chapter 4 Enroll via Device
4.1 Enroll Face via Device
Before You Start
• Power on and acvate the device. For details about the acvaon, see Acvaon .
• Enable Face Required in Set Enrollment Rule aer logging in the device backend.
St
eps
1. Tap
on the inial page.
2. Oponal: If you have added an administrator's face in Add Administrator and enabled Verify by
Administrator in Set Enrollment Rule , you should verify the administrator's permission.
Figure 4-1 Authencate Administrator Page
-
Mak
e sure the face is in the face recognion frame when authencaon.
Note
For details about face recognion, see Tip
s When Collecng/Comparing Face Picture .
-
T
ap
on the right side and enter the administrator's name and password.
3. En
ter the User Enrollment page.
-
Create an employee ID and tap Add
-
Present a card on the card presenng area.
4. Enr
oll face.
1) Tap to enter the face enrollment page.
2) Tap and follow the instrucons to enroll the face.
Note
Make sure that face is in the face recognion frame.
3) Oponal: T
ap
to enroll the face again.
4)
Tap
to complete the face enrollment.
DS-K1F600-D6E Series Enrollment Staon User Manual
5