User's Manual

Note
For details about face recognion, see Tip
s When Collecng/Comparing Face Picture .
5. Oponal: T
ap
to edit the employee ID.
4.2 Enroll Fingerprint via Device
Before You Start
•
Power on and acvate the device. For details about the acvaon, see Acvaon .
• Set ngers in Select Finger in Set Enrollment Rule aer logging in the device backend.
Steps
1. Tap
on the inial page.
2. Oponal: If y
ou have added an administrator's face in Add Administrator and enabled Verify by
Administrator in Set Enrollment Rule , you should verify the administrator's permission.
Figure 4-2 Authencate Administrator Page
-
Mak
e sure the face is in the face recognion frame when authencaon.
Note
For details about face recognion, see Tip
s When Collecng/Comparing Face Picture .
-
T
ap
on the right side and enter the administrator's name and password.
3. En
ter the User Enrollment page.
-
Create an employee ID and tap Add
-
Present a card on the card presenng area.
4. Enroll ngerprint.
1) Tap
to enter the Select Finger page.
2)
Select a nger on the Select Finger page.
Note
You can set ngers
in Set Enrollment Rule .
3) Follow the instrucons and press a nger on the ngerprint module.
If the
ngerprint is enrolled, the enrolled ngerprint on Select Finger page will turn to blue.
DS-K1F600-D6E Series Enrollment Staon
User Manual
6