User's Manual

7. Click Save.
7.12.11 Set Relay Parameters
Click Maintenance and Management → Device to enter the device list.
Click to enter the remote conguraon page.
Click Alarm → Relay . Select a relay and click and set the relay name and output delay me.
Click OK to save the sengs.
7.12.12 Set Access Control Parameters
Steps
1. On the Device for Management page, click → Others → Access Control Parameters to enter
the Access Control Parameters tab.
2. Check the checkbox to enable the funcon.
Voice Prompt
If you enable this funcon, the voice prompt is enabled in the device. You can hear the voice
prompt when operang in the device.
3. Click Save.
7.12.13 Set CPU Card Reading Mode
Steps
1. On the Device for Management page, click → Others → CPU Card Reading Sengs to enter
the CPU Card Reading Sengs tab.
2. Select a reading mode from the dropdown list.
3. Click Save.
7.12.14 Congure Volume Input or Output
Steps
1. On the Device for Management page, click → Image → Audio Input or Output to enter
Audio Input or Output tab.
2. Move the block to adjust the device output volume.
3. Click Save.
7.12.15 Operate Relay
Steps
1. Click Maintenance and Management → Device to enter the device list.
Access Control Terminal User Manual
122