User's Manual
Chapter 6 Local Sengs
6.1 Add Administrator
Aer the device acvaon, you are required to add an administrator. You can set the
administrator's user name, the card No, and ngerprint.
Steps
Note
Parts of device models supports the ngerprint funcon.
1. Enter the New Admin page.
Figure 6-1 Add Administrator
2. Enter the administrator's parameters.
ID (Employee ID)
By default, the ID No. will be increased in sequence. You can edit the ID according to your
preference.
Note
• The ID refers to the user aendance serial No.
• The ID should be between 1 and 99999999 and should not start with 0.
• The ID should be used for once.
Name
Enter the new user name.
Access Control Terminal User Manual
23