User's Manual

6.3 Communicaon Sengs

Set device wired network, RS-485, Wiegand, Wi-Fi, EHome parameters.

6.3.1 Set Wired Network

You can set the device network parameters, including the IP address, the subnet mask, the gateway

address, and the DHCP.

Steps

1. Move the cursor and select Comm. → Wired .

2. Press * to enter the Wired Network page.

Figure 6-2 Wired Network Sengs

3. Edit the IP address, the subnet mask, and the gateway.

Note

The device's IP address and the PC's should be in the same network segment.

4. Oponal: Enable DHCP.

The system will automacally assign IP address for the device.

5. Press * to save the sengs and exit the page.

6.3.2 Set Wi-Fi Parameters

You can enable the Wi-Fi funcon and you can transmit the data via Wi-Fi.

Access Control Terminal User Manual