User's Manual

Figure 6-6 Set RS-485 Parameters
2. Select an peripheral type according to your actual needs.
3. Press * and select Yes to save the sengs and exit the page.
Note
The device will reboot automacally aer change the peripheral type.
6.4 Person Management
6.4.1 Add Person
You can add users by seng the ID No., the user name, and the card No. You can also record the
user ngerprint, set the password, the department, the role and the authencaon mode.
Steps
1. Move the cursor and select User → New to enter the New page.
Access Control Terminal User Manual
29