User's Manual

Note

• The card No. is required.

• Up to 20 digits can be contained in the card No.

• The card No. can be 0.

• The card No. can start with 0 when it contains more than one numbers. E.g. 012345.

• The card No. should be unique.

FP (Fingerprint)

On the Fingerprint page, select a target nger and record according to the voice prompt.

Note

• The same ngerprint cannot be repeatedly added.

• Up to 10 ngerprints can be added to one user.

• You can also scan the ngerprints via the external ngerprint recorder and apply the

ngerprints to the device by the client soware.

• For detailed informaon about scanning the ngerprint, see Tips for Scanning Fingerprint .

• Parts of device models supports the ngerprint funcon.

Dept. (Department)

Select a department in the list and edit the department.

Note

For detailed informaon about eding the department, see .

Auth.

Select an authencaon mode when verifying user's permission.

Note

• If you select the authencaon mode as Controller, you should set the authencaon

mode in Set System Parameters . The system will authencate user's identy according to

the congured authencaon mode. By default, the authencaon mode is Controller.

This mode is applicable to edit users' authencaon modes in batch.

• If an user needs to use a special authencaon mode, which is dierent from the

authencaon mode congured in Set System Parameters , he can use card/ngerprint,

card, etc. The system will authencate the user's identy according to the congured

authencaon mode rst. This mode is applicable to edit single user's authencaon

mode, which has special permissions.

Role

Select the user's role as administrator or normal user.

• Admin: The admin has all permissions to operate the device.

• User: The normal user can check aendance on the inial page.

Access Control Terminal User Manual