User's Manual

7.4.5 Collect Fingerprint via Access Control Device
When adding person, you can collect ngerprint informaon via the access control device's
ngerprint module. The ngerprints recorded can be used as credenals of the persons to access
the authorized doors.
Before You Start
Make sure ngerprint collecon is supported by the access control device.
Steps
1. Enter Person module.
2. Select an organizaon in the organizaon list to add the person and click Add.
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
3. In the Credenal → Fingerprint panel, click +.
4. In the pop-up window, select the collecon mode as Remote.
5. Select an access control device which supports ngerprint recognion funcon from the drop-
down list.
6. Collect the ngerprint.
1) Click Start.
2) Place and li your ngerprint on the ngerprint scanner of the selected access control device
to collect the ngerprint.
3) Click Add to save the recorded ngerprint.
7. Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons .
Note
Once the ngerprint is added, the ngerprint type cannot be changed.
7.4.6 Congure Access Control Informaon
When adding a person, you can set her/his access control properes, such as seng the person as
visitor or as blacklist person, or as super user who has super authorizaon.
Steps
1. Enter Person module.
2. Select an organizaon in the organizaon list to add the person and click Add.
Access Control Terminal User Manual
59