User's Manual

Figure 7-8 Set Authencaon Modes for Card Readers
6. Oponal: Select a congured day and click Copy to Week to copy the same sengs to the
whole week.
7. Oponal: Click Copy to to copy the sengs to other card readers.
8. Click Save.
7.7.6 Congure First Person In
You can set mulple rst persons for one access control point. Aer the rst person is authorized,
it allows mulple persons access the door or other authencaon acons.
Before You Start
Set the access group and apply the access group to the access control device. For details, refer to
Set Access Group to Assign Access Authorizaon to Persons .
Perform this task when you want to congure opening door with rst person.
Steps
1. Click Access Control → Advanced Funcon → First Person In to enter the First Person In page.
2. Select an access control device in the list on the le panel.
3. Select the current mode as Enable Remaining Open aer First Person, Disable Remaining Open
aer First Person, or Authorizaon by First Person from the drop-down list for each access
control point of the selected device.
Enable Remaining Open aer First Person
The door remains open for the congured me duraon aer the rst person is authorized
unl the remain open duraon ends. If you select this mode, you should set the remain open
duraon.
Access Control Terminal User Manual
80