User's Manual

Note

Up to four aerward card readers can be added as aerward card readers for one card reader.

6. Click OK in the dialog to save the selecons.

7. Click Save in the An-Passback Sengs page to save the sengs and take eect.

Example

Set Card Swiping Path

If you select Reader In_01 as the beginning, and select Reader In_02, Reader Out_04 as the linked

card readers. Then you can only get through the access control point by swiping the card in the

order as Reader In_01, Reader In_02 and Reader Out_04.

7.7.8 Congure Device Parameters

Aer adding the access control device, you can set its parameters such as network parameters.

Set Network Parameters

Aer adding the access control device, you can set the device log uploading mode, and create ISUP

account via wired network.

Set Log Uploading Mode

You can set the mode for the device to upload logs via EHome protocol.

Steps

Note

Make sure the device is not added by EHome.

1. Enter the Access Control module.

2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .

3. Select an access control device in the device list and enter Network → Uploading Mode .

4. Select the center group from the drop-down list.

5. Check Enable to enable to set the uploading mode.

6. Select the uploading mode from the drop-down list.

Enable N1 or G1 for the main channel and the backup channel.

Select Close to disable the main channel or the backup channel

Note

• The main channel and the backup channel cannot enable N1 or G1 at the same me.

• N1 refers to wired network and G1 refers to GPRS.

Access Control Terminal User Manual