User's Manual

7. Click Save.

Create EHome Account in Wired Communicaon Mode

You can set the account for EHome protocol in wired communicaon mode. Then you can add

devices via EHome protocol.

Steps

Note

• This funcon should be supported by the device.

• Make sure the device is not added by EHome.

1. Enter the Access Control module.

2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .

3. Select an access control device in the device list and enter Network → Network Center .

4. Select the center group from the drop-down list.

5. Select the Address Type as IP Address or Domain Name.

6. Enter IP address or domain name according to the address type.

7. Enter the port number for the protocol.

Note

The port number of the wireless network and wired network should be consistent with the port

number of EHome.

8. Select the Protocol Type as EHome and select EHome version.

Note

If set the EHome version as 5.0, you should create an EHome key for the EHome account.

9. Set an account name for the network center.

10. Click Save.

Enable M1 Card Encrypon

M1 card encrypon can improve the security level of authencaon.

Steps

Note

The funcon should be supported by the access control device and the card reader.

1. Enter the Access Control module.

2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .

Access Control Terminal User Manual