User's Manual

7.1.2 Login by Acvaon Password
You should login the system before other device operaons. If you do not congure an
administrator, you should follow the instrucons below to login.
St
eps
1.
Long press OK to enter Authencate via Admin page.
2.
Pr
ess to enter the password.
-
If y
ou have added an administrator for the device, press OK and enter the password.
-
If you haven't added an administrator for the device, enter the password.
3.
Press OK to enter the home page.
Note
The device will be locked for 30 minutes aer 5 failed password aempts.
7.1.3 Forgot Password
If you forget the password during authencaon, you can change the password.
St
eps
1.
Long press OK to enter Authencate via Administrator page.
2.
Pr
ess
to enter the password entering page, and then press ESC.
3.
Select F
orgot Password.
4.
Answer the security quesons that congured when acvaon.
5.
Cr
eate a new password and conrm it.
6.
Press OK.
7.2 Communicaon Sengs
You can set the wired network, the Wi-Fi parameter, the RS-485 parameters, the Wiegand
par
ameters, ISUP and access to Hik-Connect on the communicaon sengs page.
7.2.1 Set Wired Network Parameters
You can set the device wired network parameters, including the IP address, the subnet mask, the
g
ateway, and DNS parameters.
Steps
1.
Select Basic → Comm. (Communicaon) to enter the Communicaon
sengs page.
DS-K1T320 Series Face
Recoginon Terminal User Manual
25