User's Manual

Steps
1.
Long press OK and login the device.
2.
Select User → Add User to enter the Add User page.
3.
Edit the employee ID.
Note
●
The emplo
yee ID should be less than 32 characters. And it can be a combinaon of lower
leers, upper leers, and numbers.
●
The employee ID should not be duplicated.
4.
Select the Name eld and input the user name on the keyboard.
Note
●
Number
s, upper case leers, lower case leers, and special characters are allowed in the user
name.
●
The suggested user name should be within 128 characters.
5.
Select the PIN eld to view the PIN code.
Note
The PIN code cannot be edited. It can only be applied by the plaorm.
6.
Se
t the user role.
Administrator
The user is the administrator. Except for the normal aendance funcon, the user can also
enter the Home page to operate aer
authencang the permission.
Normal User
The User is the normal user. The user can only authencate or take aendance on the inial
page.
7.
Pr
ess ESC and then press OK to save the sengs.
7.3.6 Set Authencaon Mode
Aer adding the user's face picture, password, or other credenals, you should set the
authencaon mode and the user can authencate his/her identy via the congured
authencaon mode.
St
eps
1.
Long press OK and login the device.
2.
Select User → Add User → Auth. Sengs .
3.
Select Device or Custom as the authencaon mode.
De
vice
If you want to select device mode, you should set the terminal authencaon mode in Access
Control Sengs page rst. For details see Seng Access Control Parameters.
DS-K1T320 Series Face Recoginon Terminal User Manual
35