User's Manual

Table 7-2 Access Control Parameters Descripons
Parameter Descripon
Terminal Auth. Mode Select the face recognion terminal's authencaon mode. You
can also customize the authencaon mode.
Note
●
Only the de
vice with the ngerprint module supports the
ngerprint related funcon.
●
Biometric recognion products are not 100% applicable to
an-spoong environments. If you require a higher security
level, use mulple authencaon modes.
●
If you adopt mulple authencaon modes, you should
authencate other methods before authencang face.
Enable NFC Card Enable the funcon and you can present the NFC card to
authencate.
Door Contact You can select "Remain Open" or "Remain Closed" according to
your actual needs. By default, it is "Remain Closed".
Open Duraon Set the door unlocking duraon. If the door is not opened for
the set me, the door will be locked. Available door locked me
range: 1 to 255s.
Authencaon Interval Set the device authencang interval. Available authencaon
interval range: 0 to 65535.
7.9 Time and Aendance Status Sengs
You can set the aendance mode as check in, check out, break out, break in, overme in, and
overme out according to your actual situaon.
Note
The
funcon should be used cooperavely with me and aendance funcon on the client
soware.
7.9.1 Disable Aendance Mode via Device
Disable the aendance mode and the system will not display the aendance status on the inial
page.
Select T&A t
o enter the T&A Status page.
DS-K1T320 Series Face Recoginon Terminal User Manual
42