User's Manual

Figure 7-9 Manual Aendance Mode
3.
Enable the Aendance Status Required.
4.
Enable a gr
oup of aendance status.
Note
The
Aendance Property will not be changed.
5.
Oponal: Select an s
tatus and change its name if required.
The name will be displayed on the T & A Status page and the authencaon result page.
Result
You should select an aendance status manually aer
authencaon.
Note
If you do not select a status, the authencaon will be failed and it will not be marked as a valid
aendance.
7.9.3 Set Auto Aendance via Device
Set the
aendance mode as auto, and you can set the aendance status and its available schedule.
The system will automacally change the
aendance status according to the congured schedule.
Before You Start
Add at least one user, and set the user's authencaon mode. For details, see User Management.
Steps
1.
Tap T&A Status to enter the T&A Status page.
2.
Set the Aendance Mode as Aut
o.
DS-K1T320 Series Face
Recoginon Terminal User Manual
44