User's Manual

You can congure the device card reader's parameters. If you select main card reader, you
need to congure the following parameters: Card Reader Type, Card Reader Descripon,
Enable Card Reader, Authencaon, Recognion Interval (s), Minimum Card Swiping
Interval (s), Max. Authencaon Failed Aempts Alarm/Alarm of Max. Failed
Aempts,
Enable Tampering Detecon and Enable Car
d No. Reversing.
Card Reader Type
Get card reader type.
Card Reader Descripon
Get card reader descripon. It is read-only.
Enable Card Reader
Enable the card reader's funcon.
Authencaon
Select an authencaon mode according to your actual needs from the drop-down list.
Recognion Interval
If the interval between card presenng of the same card is less than the congured value, the
card presenng is invalid. The interval me range is from 0 to 255 seconds (When set to 0, it
means that recognion interval is not enabled, and the same authencaon can be used for
unlimited mes).
Authencaon Interval
Y
ou can set the authencaon interval of the same person when authencang. The same
person can only authencate once in the congured interval. A second authencaon will be
failed.
Max. Authencaon Failed Aempts Alarm/Alarm of Max. Failed Aempts
Enable to report alarm when the card reading aempts reach the set value.
Enable T
ampering Detecon
Enable the an-tamper
detecon for the card reader.
Enable Card No. Reversing
The read card No. will be in reverse sequence aer enabling the funcon.
Set Privacy Parameters
Set the event storage type, picture upload and storage parameters, and the picture clearing
par
ameters.
Tap Conguraon → General Sengs → Privacy .
DS-K1T320 Series Face Recoginon Terminal User Manual
63