User's Manual

Extended Open Duraon
The door contact can be enabled with appropriate delay aer person with extended accesss
needs swipes her/his card.
Door Le Open Timeout Alarm
The alarm can be triggered if the door has not been closed in a congured me period. If it is
set as 0, no alarm will be triggered.
Duress Code
The door can open by inpung the duress code when there is duress. At the same me, the
client can report the duress event.
Super Password
The specic person can open the door by inpung the super password.
Note
• The duress code and the super code should be dierent.
• The duress code and the super password should be dierent from the
authencaon
password.
• The length of duress code and the super password is according the device, usually it should
contains 4 to 8 digits.
5. Click OK.
6. Oponal: Click Cop
y to , and then select the door to copy the parameters in the page to the
selected doors.
Note
The door's status duraon
sengs will be copied to the selected door(s) as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card reader parameters.
St
eps
1. Click Access Control → Advanced
Funcon → Device Parameter .
2. In the device list on the le, click
to expand the door, select a card reader and you can edit
the c
ard reader's parameters on the right.
3. Edit the card reader basic parameters in the Basic Informaon page.
Note
• The displayed parameters may vary for dierent access control devices. There are part of
par
ameters listed as follows. Refer to the user manual of the device for more details.
• Some of the following parameters are not listed in the Basic Informaon page, click Advanced
to edit the parameters.
DS-K1T341 Series Face Recognion Terminal User Manual
95