User's Manual

Before You Start
Wire the third party card readers to the device.
Steps
Note
• By default, the device disables the custom wiegand funcon. If the device enables the custom
Wieg
and funcon, all wiegand interfaces in the device will use the customized wiegand protocol.
• Up to 5 custom Wiegands can be set.
• For details about the custom Wiegand, see Custom Wiegand Rule Descripons.
1. Click Access Con
trol → Advanced Funcon → Custom Wiegand to enter the Custom Wiegand
page.
2. Select a custom Wiegand on the le.
3. Create a Wiegand name.
Note
Up to 32 characters are allowed in the custom Wiegand name.
4. Click Select De
vice to select the access control device for seng the custom wiegand.
5. Set the parity mode according to the property of the third party card reader.
Note
• Up to 80 bits are allowed in the total length.
•
The odd parity start bit, the odd parity length, the even parity start bit and the even parity
length range from 1 to 80 bit.
• The start bit of the card ID, the manufacturer code, the site code, and the OEM should range
from 1 to 80 bit.
6. Se
t output transformaon rule.
1) Click Set Rule to open the Set Output Transformaon Rules window.
DS-K1T341 Series Face Recognion Terminal User Manual
101