User's Manual

5. Set the capture mes once triggered which denes how many pictures will be captures for one
me.
6. If the c
apture mes is more than 1, set the interval for each capture.
7. Click Save.
Set Manual Capture Parameters
In Status Monitoring module, you can capture a picture manually the access control device's
camera by clicking a buon. Before that, you need to set the parameters for the capture such as
picture quality.
Before You Start
Before seng the capture parameters, you should set the saving path rst to dene where the
captured pictures are saved. For details, refer to Set Picture Storage in the user manual of the
client soware.
Steps
Note
This funcon should be supported by the device
1. En
ter the Access Control module.
2. On the navigaon bar on the le, enter Adv
anced Funcon → More Parameters → Capture .
3. Select an access control device in the device list and select Manual Capture.
4. Select the resoluon of the captured pictures from the drop-down list.
5. Select the picture quality as High, Medium, or Low. The higher the picture quality is, the larger
size the picture will be.
6. Click Save.
Set Parameters for Face Recognion Terminal
For face
recognion terminal, you can set its parameters.
Steps
Note
This funcon should be supported by the device.
1. En
ter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and click Face Recognion Terminal.
4. Set the parameters.
DS-K1T341 Series Face Recognion Terminal User Manual
109