User's Manual

Note
These parameters displayed vary according to dierent device models.
Algorithm
Select Deep Learning as the f
ace picture database.
Save Authencang Face Picture
If enabled, the captured face picture when authencang will be saved on the device.
ECO Mode
Aer enabling the ECO mode, the device can authencate faces in the low light or dark
environment. And you can set he ECO mode threshold, ECO mode (1:N), and ECO mode (1:1).
Note
Only device in the normal mode supports conguring ECO mode parameters.
Work Mode
Se
t the device work mode as Access Control Mode. The access control mode is the device
normal mode. You should authencate your credenal for accessing.
5. Click Save.
Enable M1 Card Encrypon
M1 card encrypon can improve the security level of authencaon.
Steps
Note
The
funcon should be supported by the access control device and the card reader.
1. En
ter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and click M1 Card Encrypon to enter the M1
Card Encrypon page.
4. Set the switch to on to enable the M1 card encrypon
funcon.
5. Set the sector ID.
Note
• The sector ID ranges from 1 to 100.
•
By default, Sector 13 is encrypted. It is recommended to encrypt sector 13.
6. Click Sa
ve to save the sengs.
DS-K1T341 Series Face Recognion Terminal User Manual
110