User's Manual

Main Channel
The device will communicate with the center via the main channel.
Note
N1 refers to wired network.
7.12.9 Network Center Parameters Sengs
You can set the nofy surveillance center, center's IP address, the port No., the protocol (EHome),
the EHome acc
ount user name,etc. to transmit data via EHome protocol.
On the Device for Management page, click
→ Network → Ne
twork Center Parameters to enter
the Network Center Parameters Sengs tab.
Select a center from the drop-down list.
Aer enabling the funcon, you can set the center's address type, IP address/domain name, port
No., EHome user name, etc.
Click Save.
7.12.10 Congure SIP Parameters
Set the master staon's IP address and the SIP server's IP address. Aer seng the parameters,
you can communicate among the access control device, door staon, indoor staon, master
staon, and the plaorm.
Note
Only the access control device and other devices or systems (such as door staon, indoor staon,
master staon,
plaorm) are in the same IP segment, the two-way audio can be performed.
Click Main
tenance and Management → Device to enter the device list.
Click
to enter the remote conguraon page.
Click Ne
twork → Linked Network Conguraon and set the master staon's IP address and SIP
server's IP address.
Click Save.
7.12.11 Set Access Control Parameters
Steps
1. On the De
vice for Management page, click
→ Others → Access Con
trol Parameters to enter
the Access Control Parameters tab.
2. Check the checkbox to enable the funcon.
Voice Prompt
DS-K1T341 Series Face Recognion Terminal User Manual
147