User's Manual

4.3 Wire Normal Device
You can connect the terminal with normal peripherals.
Figure 4-7 Device Wiring
Note
• You should set the face recognion terminal's Wiegand direcon as Input t
o connect to a
Wiegand card reader. If connects to an access controller, you should set the Wiegand direcon as
Output to transmit authencaon informaon to the access controller.
• For details about Wiegand direcon sengs, see Set Wiegand Parameters .
• The suggested external power supply for door lock is 12 V, 1 A. The suggested external power
supply for the Wiegand card reader is 12 V, 1A.
• If the interface for network connecon is too large, you can use the supplied cable as shown
below.
Figure 4-8 Cable Diagram
4.4 Wire Secure Door Control Unit
You can connect the terminal with the secure door control unit.
The wiring diagr
am is as follows.
DS-K1T341 Series Face Recognion Terminal User Manual
23