User's Manual

6.5.2 Import Data
Steps
1. Plug a USB ash drive in the device.
2. On the T
ransfer page, tap Import User Data, Import Prole Photo.
3. Tap Yes on the pop-up window and the data will be imported from the USB ash drive to the
device.
Note
• If you want to transfer all user informaon from one device (Device A) to another (Device B),
y
ou should export the informaon from Device A to the USB ash drive and then import from
the USB ash drive to Device B. In this case, you should import the user data before imporng
the prole photo.
• The supported USB ash drive format is FAT32.
•
The imported pictures should be saved in the root directory (enroll_pic) and the picture le's
name should be follow the rule below:
Card No._Name_Department_Employee ID_Gender.jpg
• The employee ID should be less than 32 characters. It can be a combinaon of lower leers,
upper leers, and numbers. It should not be duplicated, and should not start with 0.
• Requirements of face picture should follow the rules below: It should be taken in full-face
view, directly facing the camera. Do not wear a hat or head covering when taking the face
picture. The format should be JPEG or JPG. The resoluon should be 640 × 480 pixel or more
than of 640 × 480 pix
el. The picture size should be between 60 KB and 200 KB.
6.6 Identy
Authencaon
Aer network conguraon, system parameters conguraon and user conguraon, you can go
back to the inial page for identy authencaon. The system will authencate person according
to the congured authencaon mode.
You can authencate identy via 1:1 matching or 1:N matching.
1:N Matching
Compare the captured face picture with all face pictures stored in the device.
1: 1 Matching
Compare the captured face picture with all face pictures stored in the device.
6.6.1 Authencate via Single Credenal
Set the user authencaon type before authencaon. For details, see Se
t Authencaon Mode .
Authencate face or card.
DS-K1T341 Series Face Recognion Terminal User Manual
46