User's Manual

Tap Info. (System Informaon) → QR Code to enter the QR code page. And you can view the
device QR code.
6.12 Two-Way Audio
Aer adding the device to the client soware, you can call the device from the client soware, call
the master staon from the device, call the client soware from the device, or call the indoor
staon from the device.
6.12.1 Call Client Soware from Device
Steps
1. Get the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the client soware and the control panel of the soware pops up.
3. Click Device Management to enter the Device Management interface.
4. Add the device to the client soware.
Note
For details about adding device, see Add De
vice.
5. Call the clien
t soware.
1) Tap Call on the device inial page.
2) Input 0 in the pop-up window.
3) Tap Call to call the client soware.
6. T
ap Answer on the pop-up page of the client soware and you can start two-way audio
between the device and the client soware.
Note
If the device is added to mulple client sowares and when the device is calling the client
soware, only the rst client soware added the device will pop up the call receiving window.
6.12.2 Call Master Staon from Device
Steps
1. Ge
t the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the client soware and the control panel of the soware pops up.
3. Click De
vice Management to enter the Device Management interface.
4. Add the master staon and the device to the client soware.
DS-K1T341 Series Face
Recognion Terminal User Manual
64