User's Manual

3. Click Add Face in the Basic Informaon panel.
4. Select R
emote Collecon.
5. Select an access control device which supports face recognion funcon from the drop-down
list.
6. Collect face.
1) Face to the camera of the selected access control device and make sure your face is in the
middle of the collecng window.
2) Click
to capture a photo.
3)
Click OK to save the captured photo.
7. Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons .
7.4.7 Congure Access Control Informaon
When adding a person, you can set her/his access control properes, such as seng the person as
visitor or as blacklist person, or as super user who has super authorizaon.
Steps
1. Enter Person module.
2. Select an organizaon in the organizaon list to add the person and click Add.
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
3. In the Access Con
trol panel, set the person's access control properes.
PIN Code
The PIN code must be used aer card or ngerprint when accessing. It cannot be used
independen
tly. It should contain 4 to 8 digits.
Device Operator
For person with device operator role, he/she is authorized to operate on the access control
devices.
Note
The Super User, Extended Door Open Time, Add to Blacklist, and Mark as Visitor funcons
cannot be enabled concurrently. For example, if one person is set as super user, you cannot
enable e
xtended door open me for her/him, add her/him to the blacklist, or set her/him as
visitor.
4. Conrm to add the person.
-
Click Add t
o add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons.
DS-K1T341 Series Face Recognion Terminal User Manual
82