User's Manual

Send an email nocaon about the event to one or more receivers.
For details about seng email parameters, refer to Set Email Parameters in the user
manual of the client soware.
2) Click OK.
5.
Enable the event so that when the event is detected, event will be sent to the client and the
linkage acons will be triggered.
6.
Oponal: Click Copy to to copy the event sengs to other access control device, alarm input,
door, or card reader.
9.8.2 Congure Device Acons for Access Event
You can set the access control device's linkage acons for the access control device's triggered
event. When the event is triggered, it can trigger the alarm output, host buzzer, and other acons
on the same device.
Steps
Note
It should be supported by the device.
1.
Click Access Control → Linkage Conguraon .
2.
Select the access control device from the list on the
le.
3.
Click Add buon to add a new linkage.
4.
Select the event source as Event Linkage.
5.
select the event type and detailed event to set the linkage.
6.
In the Linkage Target area, set the property target to enable this
acon.
Buzzer on Controller
The audible warning of access control device will be triggered.
7.
Click Save.
8.
Oponal: Aer adding the device linkage, you can do one or more of the following:
Edit Linkage
Sengs
Select the congured linkage sengs in the device list and you can edit its
event source parameters, including event source and linkage target.
Delete Linkage
Sengs
Select the congured linkage sengs in the device list and click Delete to
delete it.
9.8.3 Congure Device Acons for Card Swiping
You can set the access control device's linkage acons for the specied card swiping. When you
swipe the
specied card, it can trigger the alarm output, host buzzer, and other acons on the
same device.
Access Control Terminal User Manual
109