User's Manual

6. Click OK.
Figure 8-5 Set Authencaon Modes for Persons
7. Oponal: Select per
son(s) on the Person Authencaon mode page, and then click Apply to
apply the person authencaon mode to the device.
Note
Person
authencaon has higher priority than other authencaon mode. When the access
control device has been congured person authencaon mode, the person should
authencate on this device via person authencaon mode.
8.7.6 Congure Card Reader Authencaon Mode and Schedule
You can set the passing rules for the card reader of the access control device according to your
actual needs.
P
erform this task if you need to congure the card reader's authencaon mode and schedule.
Steps
1. Click Access Control → Advanced Funcon → Car
d Reader Authencaon to enter the card
reader authencaon conguraon page.
2. Select a card reader on the le to congure.
3. Se
t card reader authencaon mode.
1) Click Conguraon.
Note
• Password refers to the card password set when issuing the card to the person. For details,
r
efer to Add Single Person.
• Authencaon password refers to the password set to open the door. Refer to Congure
Authencaon Password.
• The supported card reader authencaon mode varies according to dierent devices. For
details, refer to the actual product.
2) Select the modes and click to add to the selected modes list.
DS-K1T642 Series Face Recognion Terminal User Manual
93