User's Manual

Steps
Note
This funcon should be supported by the device.
1. En
ter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and click Wiegand to enter the Wiegand
Sengs page.
4. Set the switch to on to enable the Wiegand funcon for the device.
5. Select the Wieg
and channel No. and the communicaon mode from the drop-down list.
Note
If you set Communicaon Direcon as Sending, y
ou are required to set the Wiegand Mode as
Wiegand 26 or Wiegand 34.
6. Check Enable Wieg
and to enable the Wiegand funcon.
7. Click Save.
• The congured parameters will be applied to the device automacally.
• Aer changing the communicaon direcon, the device will reboot automacally.
Enable M1 Card Encrypon
M1 card
encrypon can improve the security level of authencaon.
Steps
Note
The
funcon should be supported by the access control device and the card reader.
1. En
ter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and click M1 Card Encrypon to enter the M1
Car
d Encrypon page.
4. Set the switch to on to enable the M1 card encrypon funcon.
5. Set the sector ID.
Note
• The sector ID ranges from 1 to 100.
•
By default, Sector 13 is encrypted. It is recommended to encrypt sector 13.
6. Click Sa
ve to save the sengs.
DS-K1T642 Series Face Recognion Terminal User Manual
101