User's Manual

Figure 6-6 Wi-Fi
Sengs
3. Enable the Wi-Fi funcon.
4. Congure the Wi-Fi parameters.
-
Select a Wi-Fi from the list, and enter the Wi-Fi's password. Tap OK.
-
If the target Wi-Fi is not in the list,tap Add Wi-Fi. Enter the Wi-Fi's name and password. And
tap OK.
Note
Only digits, leers,
and special characters are allowed in the password.
5. Se
t the Wi-Fi's parameters.
-
By default, DHCP is enable. The system will allocate the IP address, the subnet mask, and the
gateway automacally.
-
If disable DHCP
, you should enter the IP address, the subnet mask, and the gateway
manually.
6. Tap OK to save the sengs and go back to the Wi-Fi tab.
7. Tap
to save the network parameters.
6.4.3 Set RS-485 Parameters
The face
recognion terminal can connect external access controller, secure door control unit or
card reader via the RS-485 terminal.
Steps
1. Tap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2. On the Communicaon Sengs page, tap R
S-485 to enter the RS-485 tab.
DS-K1T642 Series Face Recognion Terminal User Manual
21