User's Manual

Note
• Only numbers are allowed in the password.
•
Up to 8 characters are allowed in the password.
6. Se
t the user role.
Administrator
The user is the administrator. Except for the normal aendance funcon, the user can also
en
ter the Home page to operate aer authencang the permission.
Normal User
The User is the normal user. The user can only authencate or take aendance on the inial
page.
7. Tap
to save the
sengs.
6.5.5 Set Authencaon Mode
Aer adding the user's face picture, ngerprint, password, or other credenals, you should set the
authencaon mode and the user can authencate his/her identy via the congured
authenc
aon mode.
Steps
1. Long tap on the inial page for 3 s and slide to the le/right by following the gesture and log in
the back
end.
2. Tap User → Add User/Edit User → Authencaon Mode .
3. Select Device or Custom as the authencaon mode.
Device
If you want to select device mode, you should set the terminal authencaon mode in
Access Con
trol Sengs page rst. For details see Seng Access Control Parameters.
Custom
You can combine dierent authencaon
modes together according to your actual needs.
4. Tap
to save the
sengs.
6.5.6 Search and Edit User
Aer adding the user, you can search the user and edit it.
Search User
On the User Management page, Tap
to enter the Search User page. Tap Car
d on the le of the
page and select a search type from the drop-down list. Enter the employee ID, card No., or the user
name for search. Tap
to search.
DS-K1T642 Series Face Recognion Terminal User Manual
28