User's Manual

Figure 8-4 Set Output Transformaon Rule
2) Select rules on the le list.
The selected rules will be added to the right list.
3)
Oponal: Drag the rules to change the rule order.
4) Click OK.
5) In the Custom Wiegand tab, set the rule's start bit, length, and the decimal digit.
7. Click Save.
8.7.5
Congure Person Authencaon Mode
You can set the passing rules for person to the specied the access control device according to your
actual needs.
Before You Start
Make sure the access control device support the
funcon of person authencaon.
Steps
1. Click Access Control → Advanced
Funcon → Authencaon .
2. Select an access control device (support the funcon of person authencaon) on the le panel
to enter the person
Authencaon Mode page.
3. Click Add to enter the Add window.
4. Select the person(s) need to be congured on the le panel.
The selected person(s) will be added to the right panel.
5. Select the
authencaon mode on the drop-down list of Authencaon Mode.
DS-K1T642 Series Face Recognion Terminal User Manual
92