User's Manual

6. Click OK.
Figure 8-5 Set Authencaon Modes for Persons
7. Oponal: Select person(s) on the Person Authencaon mode page, and then click Apply to
apply the person authencaon mode to the device.
Note
Person authencaon has higher priority than other authencaon mode. When the access
control device has been congured person authencaon mode, the person should
authencate on this device via person authencaon mode.
8.7.6 Congure Card Reader Authencaon Mode and Schedule
You can set the passing rules for the card reader of the access control device according to your
actual needs.
Perform this task if you need to
congure the card reader's authencaon mode and schedule.
Steps
1. Click Access Control → Advanced Funcon → Card Reader Authencaon to enter the card
reader authencaon conguraon page.
2. Select a card reader on the
le to congure.
3. Set card reader authencaon mode.
1) Click Conguraon.
Note
• Password refers to the card password set when issuing the card to the person. For details,
refer to Add Single Person.
• Authencaon password refers to the password set to open the door. Refer to Congure
Authencaon Password.
• The supported card reader
authencaon mode varies according to dierent devices. For
details, refer to the actual product.
2) Select the modes and click to add to the selected modes list.
DS-K1T642 Series Face Recognion Terminal User Manual
93