User's Manual

3) Oponal: Click or to adjust the display order.
4) Click OK.
Aer selecng the modes, the selected modes will display as icons.
4. Click the icon to select a card reader
authencaon mode, and drag on the day to draw a color
bar on the schedule, which means in that period of me, the card reader authencaon is valid.
5. Repeat the above step to set other
me periods.
6.
Oponal: Select a congured day and click Copy to Week to copy the same sengs to the
whole week.
7.
Oponal: Click Copy to to copy the sengs to other card readers.
8. Click Save.
8.7.7
Congure First Person In
You can set mulple rst persons for one access control point. Aer the rst person is authorized,
it allows
mulple persons access the door or other authencaon acons.
Before You Start
Set the access group and apply the access group to the access control device. For details, refer to
Set Access Group to Assign Access Authorizaon to Persons .
Perform this task when you want to
congure opening door with rst person.
Steps
1. Click Access Control → Advanced Funcon → First Person In to enter the First Person In page.
2. Select an access control device in the list on the le panel.
3. Select the current mode as Enable Remaining Open
aer First Person or Disable Remaining
Open aer First Person from the drop-down list for each access control point of the selected
device.
Enable Remaining Open
aer First Person
The door remains open for the congured me duraon aer the rst person is authorized
unl the remain open duraon ends. If you select this mode, you should set the remain open
duraon.
Note
The remain open duraon should be between 0 and 1440 minutes. By default, the remain
open duraon is 10 minutes.
Disable Remaining Open aer First Person
Disable the funcon of rst person in, namely normal authencaon.
Note
You can authencate by the rst person again to disable the rst person mode.
4. Click Add on the First Person List panel.
DS-K1T642 Series Face Recognion Terminal User Manual
94