User's Manual

Set Manual Capture Parameters
In Status Monitoring module, you can capture a picture manually the access control device's
camera by clicking a
buon. Before that, you need to set the parameters for the capture such as
picture quality.
Before You Start
Before seng the capture parameters, you should set the saving path rst to dene where the
captured pictures are saved. For details, refer to Set Picture Storage in the user manual of the
client
soware.
Steps
Note
This funcon should be supported by the device
1. Enter the Access Control module.
2. On the
navigaon bar on the le, enter Advanced Funcon → More Parameters → Capture .
3. Select an access control device in the device list and select Manual Capture.
4. Select the resoluon of the captured pictures from the drop-down list.
5. Select the picture quality as High, Medium, or Low. The higher the picture quality is, the larger
size the picture will be.
6. Click Save.
Set Parameters for Face
Recognion Terminal
For face recognion terminal, you can set its parameters.
Steps
Note
This funcon should be supported by the device.
1. Enter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and click Face
Recognion Terminal.
4. Set the parameters.
Note
These parameters displayed vary according to dierent device models.
Algorithm
Select Deep Learning as the face picture database.
Save Authencang Face Picture
DS-K1T642 Series Face Recognion Terminal User Manual
99