User's Manual

Overme Level for Workday
When you work for certain period aer end-work me on workday, you will reach dierent
overme level: overme level 1, overme level 2 and overme level 3 . You can set dierent
pay rate for three overme levels, respecvely.
Pay Rate
Set corresponding pay rates for three overme levels, which can be generally used to
calculate total work hours.
Overme Rule for Non-Workday
You can enable overme rule for non-workday and set calculaon mode.
4. Click Save.
Congure
Aendance Check Point
You can set the card reader(s) of the access point as the aendance check point, so that the
authencaon on the card readers will be recorded for aendance .
Before You Start
You should add access control device before conguring aendance check point. For details, refer
to Add Device .
Steps
Note
By default, all card readers of the added access control devices are set as aendance checkpoint.
1. Enter the Time & Aendance module.
2. Click Aendance Sengs → Aendance Check Point to enter the Aendance Check Point
Sengs page.
3. Oponal: Set Set All Card Readers as Check Points switch to o.
Only the card readers in the list will be set as the aendance check points.
4. Check the desired card reader(s) in the device list as aendance check point(s).
5. Set check point funcon as Start/End-Work, Start-Work or End-Work.
6. Click Set as Check Point.
The
congured aendance check point displays on the right list.
Congure
Holiday
You can add the holiday during which the check-in or check-out will not be recorded.
DS-K1T642 Series Face Recognion Terminal User Manual
114