User's Manual

5. Set table parameters of database according to the actual
conguraons.
1) Enter the table name of the third-party database.
2) Set the mapped table elds between the client soware and the third-party database.
6. Click Connecon Test to test whether database can be connected.
7. Click Save to save the
sengs.
The aendance data will be wrien to the third-party database.
Congure Break Time
You can add break me and set start me, end me, duraon, calculaon mode and other
parameters for the break. The added break
me can also be edited or deleted.
Steps
1. Click Time & Aendance → Timetable .
The added
metables are displayed in the list.
2. Select an added metable or click Add to enter seng metable page.
3. Click Sengs in the break me area to enter break me management page.
4. Add break
me.
1) Click Add.
2) Enter a name for the break
me.
3) Set related parameters for the break me.
Start Time / End Time
Set the me when the break starts and ends.
No Earlier Than / No Later Than
Set the earliest swiping me for starng break and the latest swiping me for ending
break.
Break Duraon
The duraon from start me to end me of the break.
Calculaon
Auto Deduct
The xed break duraon will be excluded from work hours.
Must Check
The break
duraon will be calculated and excluded from work hours according to
actual check-in and check-out me.
Note
If you select Must Check as calculaon method, you need to set aendance status for
late or early returning from break.
5. Click Save to save the sengs.
6. Oponal: Click Add to connue adding break me.
DS-K1T642 Series Face Recognion Terminal User Manual
117