User's Manual

Steps
Note
The funcon should be supported by the device.
1.
Click
Conguraon → Network → Basic Sengs → Wi-Fi .
2. Check Enable Wi-Fi.
3. Select a Wi-Fi
-
Click
of a Wi-Fi in the list and enter the Wi-Fi password.
-
Click Add and enter a Wi-Fi's SSID, password, and
encrypon type. Click Connect. When the
Wi-Fi is connected, click OK.
4.
Oponal: Set the WLAN parameters.
1) Click TCP/IP Sengs.
2) Set the IP address, subnet mask, and default gateway. Or checkEnable DHCP and the system
will allocate the IP address, subnet mask, and default gateway
automacally.
5. Click Save.
7.4.8 Set Video and Audio Parameters
Set the image quality, resoluon, and the device volume.
Set Video Parameters
Click Conguraon → Video/Audio → Video .
Set the stream type, the video type, the bitrate type, the frame rate, and the Max. bitrate.
Click Save to save the
sengs aer the conguraon.
Set Audio Parameters
Click Conguraon → Video/Audio → Audio .
Drag the block to adjust the device output volume.
Click Save to save the
sengs aer the conguraon.
7.4.9 Customize Audio Content
Customize the output audio content when authencaon succeeded and failed.
Steps
1. Click Conguraon → Video/Audio → Audio Prompt .
2. Enable the
funcon.
3. Select an appellaon.
4. Set the me duraon when authencaon succeeded.
1) Click Add.
2) Set the
me duraon.
DS-K1T642 Series Face Recognion Terminal User Manual
48