User's Manual

Aer seng the parameters, you can communicate among the access control device, door staon,
indoor staon, master staon, and the plaorm.
Click Save to save the sengs aer the conguraon.
7.4.11 Set Access Control and Authencaon Parameters
Set the access control parameters and the authencaon parameters.
Set Door Parameters
Click Conguraon → Access Control → Door Parameters .
Click Save to save the
sengs aer the conguraon.
Door Contact
You can select Remain Open or Remain Closed according to your actual needs. By default, it is
Remain Closed.
Open Time
Set the door unlocking
duraon. If the door is not opened for the set me, the door will be
locked.
Door Open Timeout Alarm
An alarm will be triggered if the door has not been closed within the congured me duraon.
Set Authencaon Parameters
Click Conguraon → Access Control → Authencaon Sengs .
Click Save to save the
sengs aer the conguraon.
Authencaon Mode
Select an authencaon mode according to your actual needs from the drop-down list.
Display Authencaon Result
Check Face Picture, Name, or Employee ID. When
authencaon is completed, the system will
display the selected contents in the result.
Minimum Card Presenng Interval
If the interval between card presenng of the same card is less than the congured value, the
card
presenng is invalid.
7.4.12 Set Image Parameters
Set the video standard, WDR, brightness, contrast, saturaon, and sharpness.
Steps
1. Click Conguraon → Image .
2.
Congure the parameters to adjust the image.
DS-K1T642 Series Face Recognion Terminal User Manual
50