User's Manual

Note
• This
funcon should be supported by the device.
• You can log into the device to get the cercate le by web browser.
7. Check Synchronize Time to synchronize the device
me with the PC running the client aer
adding the device to the client.
8.
Oponal: Check Import to Group to create a group by the device name.
9. Finish adding the device.
-
Click Add to add the device and back to the device list page.
-
Click Add and New to save the sengs and connue to add other device.
10. Oponal: Perform the following operaon(s).
Remote
Conguraon
Click on Operaon column to set remote conguraon of the
corresponding device.
Note
For detail operaon steps for the remote conguraon, see the
user manual of the device.
Device Status Click on Operaon column to view device status, including
cameras, recording status, signal status, hardware status, etc.
Edit Device
Informaon
Click on Operaon column to edit the device informaon, such
as IP address, user name, and password.
Check Online User Click on Operaon column to check the online users who access
the device, such as user name, user type, user's IP address, and
login me.
Refresh Click on Operaon column to get the latest device informaon.
Delete Device Select one or mulple devices and click Delete to delete the
selected device(s) from the client.
Add Device by EHome Account
For access control devices supports EHome 5.0 protocol, you can add them to the client by EHome
protocol aer entering device ID and key, if you have congured their server addresses, port No.,
and device IDs.
Before You Start
Make sure the devices have connected to the network properly.
Steps
1. Enter Device Management module.
The added devices are displayed on the right panel.
DS-K1T642 Series Face Recognion Terminal User Manual
60