User's Manual

Steps
1.
Click Access Control → Advanced Funcon → Authencaon .
2.
Select an access control device (support the funcon of person authencaon) on the le panel
to enter the person Authencaon Mode page.
3.
Click Add t
o enter the Add window.
4.
Select the person(s) need to be congured on the le panel.
The select
ed person(s) will be added to the right panel.
5.
Select the authencaon mode on the drop-down list of Authencaon Mode.
6.
Click OK.
Figure 10-10 Set Authencaon Modes for Persons
7.
Oponal: Select per
son(s) on the Person Authencaon mode page, and then click Apply to
apply the person authencaon mode to the device.
Note
Person
authencaon has higher priority than other authencaon mode. When the access
control device has been congured person authencaon mode, the person should authencate
on this device via person authencaon mode.
10.7.6 Congure Card Reader Authencaon Mode and Schedule
You can set the passing rules for the card reader of the access control device according to your
actual needs.
St
eps
1.
Click Access Control → Advanced Funcon → Authencaon to enter the authencaon mode
conguraon page.
2.
Select a c
ard reader on the le to congure.
3.
Se
t card reader authencaon mode.
1) Click Conguraon.
DS-K6300 Series Payment Terminal User Manual
119