User's Manual

Figure 4-19 Study Mode
2.
Adjus
t the closed posion of the barrier.
3.
Power on the device.
The device will remember the current posion (closed posion) automacally.
4.
Power o the device.
5.
Set the No.1 switches of the 2-digit DIP Switch on the main user extended interface board by
referring to the following gure.
Figure 4-20 Normal Mode
6.
P
ower on the device again.
Note
For details about the DIP switch value and meaning, see DIP S
witch Descripon.
The barrier will open automacally and turns back to the closed posion. At this circumstance,
the de
vice enters the normal mode.
4.4.3 Keyfob Pairing
Pair keyfob via buon or DIP switch.
Pair Keyfob via Buon
Pair the remote control to the device via
buon to open/close the barrier remotely.
Steps
1.
Set the conguraon No. to "2" and the parameter to "2".
The de
vice enters the keyfob pairing mode.
2.
Hold the Close buon for more than 10 seconds.
The keyfob's indicator of the will ash twice if the pairing is completed.
DS-K3B220X Series Swing Barrier User Manual
28