User's Manual

Congure Parameters for Access Control Device
Aer adding the access control device, you can congure its parameters, including overlaying user
informaon on picture, uploading pictures aer capturing, saving captured pictures, etc.
Be
fore You Start
Add access control device to the client.
Steps
1.
Click Access Control → Advanced Funcon → De
vice Parameter .
Note
If you can not nd Device Parameter in the Advanced Funcon list, hover the cursor on the
Adv
anced Funcon, and then Click
to select the Device Parameter to be displayed.
2.
Select an access de
vice to show its parameters on the right page.
3.
Turn the switch to ON to enable the corresponding funcons.
Note
●
The displa
yed parameters may vary for dierent access control devices.
●
Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
RS-485 Comm. Redundancy
Y
ou should enable this funcon if you wire the RS-485 card reader to the access control
device redundantly.
Display Detected Face
Display face picture when authencang.
Display Card Number
Displa
y the card informaon when authencang.
Display Person Informaon
Display the person informaon when
authencang.
Overlay Person Info. on Picture
Display the person informaon on the captured picture.
Voice Prompt
If you enable this funcon, the voice prompt is enabled in the device. You can hear the voice
prompt when operang in the device.
Upload Pic. Aer Linked Capture
Upload the pictur
es captured by linked camera to the system automacally.
Save Pic. Aer Linked Capture
If you enable this funcon, you can save the picture captured by linked camera to the device.
DS-K3B220X Series Swing Barrier User Manual
79