User's Manual

Press Key to Enter Card Number
If you enable this function, you can input the card No. by pressing the key.
NFC An i-Cloning
If you enable this funcon, you cannot use the cloned card for authencaon and further
enhance security.
4.
Click OK.
5.
Oponal: Click Copy to, and then select the access control device(s) to copy the parameters in
the page to the selected device(s).
Congure Parameters for Door/Elevator
Aer adding the access control device, you can congure its access point (door or oor)
parameters.
Before You Start
Add access control device to the client.
Steps
1.
Click Access Control
→ Advanced Funcon → Device Parameter .
2.
Select an access control device on the le panel, and then click
to show the doors or oors of
the selected device.
3.
Select a door or oor to show its parameters on the right page.
4.
Edit the door or oor parameters.
Note
●
The displayed parameters may vary for dierent access control devices.
●
Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
Name
Edit the card reader name as desired.
Door Contact
You can set the door sensor as remaining closed or remaining open. Usually, it is remaining
closed.
Exit Buon Type
DS
-K3B220X Series Swing Barrier User Manual
80
You can set the exit buon as remaining closed or remaining open. Usually, it is remaining
open.