User's Manual

Note
●
F
or the card related funcons(the type of access control card/mul-factor authencaon), only
the card(s) with access group applied will be listed when adding cards.
●
The advanced funcons should be supported by the device.
●
Hover the cursor on the Advanced Funcon, and then Click
to customize the advanced
funcon(s) to be displayed.
10.7.1 Congure Device Parameters
Aer adding the access control device, you can congure the parameters of access control device
(access c
ontroller), access control points (door or oor), alarm inputs, alarm outputs, card readers
and lane controller.
Congure Parameters for Access Control Device
Aer adding the access control device, you can congure its parameters, including overlaying user
informaon on picture, uploading pictures aer capturing, saving captured pictures, etc.
Before You Start
Add access control device to the client.
Steps
1.
Click Access Control → Advanced Funcon → De
vice Parameter .
Note
If you can not nd Device Parameter in the Advanced Funcon list, hover the cursor on the
Adv
anced Funcon, and then Click
to select the Device Parameter to be displayed.
2.
Select an access de
vice to show its parameters on the right page.
3.
Turn the switch to ON to enable the corresponding funcons.
Note
●
The displa
yed parameters may vary for dierent access control devices.
●
Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
RS-485 Comm. Redundancy
Y
ou should enable this funcon if you wire the RS-485 card reader to the access control
device redundantly.
Display Detected Face
Display face picture when authencang.
Display Card Number
DS-K3B631TX Series Swing Barrier User Manual
126