User's Manual

Swing Barrier·User Manual
93
Setting Route Anti-passing Back
Purpose:
The route anti-passing back depends on the card swiping route. You should set the first card reader
and the card readers afterwards.
Steps:
1. Check the Enable Cross-Controller Anti-passing Back checkbox to enable the function.
2. Set the anti-passing back parameters.
 Based on Card
Note: The system will judge the anti-passing back according to the entrance and exit
records on the card.
1) Select Based on Card as the anti-passing back mode in the drop-down list.
2) Select Route Anti-passing Back as the rule.
3) Set the sector ID.
4) Click Select Access Controller to select a device in the pop-up window.
5) In the Card Reader area, click the icon on the left of the card reader column to select
the first card reader. The icon will turn to .
6) Click the card reader afterward input field to select the card readers afterward in the
pop-up window.
7) Check the checkbox in the Enable Anti-passing Back column to enable the anti-passing
back function.
Notes:
 The displayed card readers in the card reader afterward input field should be in
authentication order.
 Up to 64 devices with anti-passing back function can be added.
 Up to 16 card readers afterward can be added for each card reader.
 It supports M1 card at present and the sector cannot be encrypted.