Quick Start Guide
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Models
- Chapter 1 Overview
- Chapter 2 System Wiring
- Chapter 3 Installation
- Chapter 4 General Wiring
- 4.1 Components Introduction
- 4.2 Wiring Electric Supply
- 4.3 Wire Interconnecting Cable
- 4.4 Face Recognition Terminal Power Supply Wiring (Optional)
- 4.5 Terminal Description
- 4.5.1 UART Related Terminal and Position
- 4.5.2 Main Control Board Terminal Description
- 4.5.3 Sub Control Board Terminal Description
- 4.5.4 BUS Terminal Description
- 4.5.5 Access Control Board Terminal Description
- 4.5.6 Access Control Board UART Description
- 4.5.7 RS-485 Wiring
- 4.5.8 RS-232 Wiring
- 4.5.9 Barrier Control Wiring
- 4.5.10 Alarm Output Wiring
- Chapter 5 Device Settings
- Chapter 6 Activation
- Appendix A. DIP Switch Description
- Appendix B. Event and Alarm Type
- Appendix C. Table of Audio Index Related Content
- Appendix D. Error Code Description
- Appendix E. Communication Matrix and Device Command
Note
Please check and avoid metal pieces dropped into the high and low voltage modules, which will
c
ause short circuit.
3.2 Install Pedestals
Before You Start
Pr
epare for the installaon tools, check the device and the accessories, and clear the installaon
base.
Steps
Note
●
The de
vice should be installed on the concrete surface or other non-ammable surfaces.
●
For opening the pedestal conveniently, make sure the distance between the pedestal and the
wall should be more than 10 mm.
●
The dimension is as f
ollows.
DS-K3Y411X Series Flap Barrier Quick Start Guide
7