Quick Start Guide
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Models
- Chapter 1 Overview
- Chapter 2 System Wiring
- Chapter 3 Installation
- Chapter 4 General Wiring
- 4.1 Components Introduction
- 4.2 Wiring Electric Supply
- 4.3 Wire Interconnecting Cable
- 4.4 Face Recognition Terminal Power Supply Wiring (Optional)
- 4.5 Terminal Description
- 4.5.1 UART Related Terminal and Position
- 4.5.2 Main Control Board Terminal Description
- 4.5.3 Sub Control Board Terminal Description
- 4.5.4 BUS Terminal Description
- 4.5.5 Access Control Board Terminal Description
- 4.5.6 Access Control Board UART Description
- 4.5.7 RS-485 Wiring
- 4.5.8 RS-232 Wiring
- 4.5.9 Barrier Control Wiring
- 4.5.10 Alarm Output Wiring
- Chapter 5 Device Settings
- Chapter 6 Activation
- Appendix A. DIP Switch Description
- Appendix B. Event and Alarm Type
- Appendix C. Table of Audio Index Related Content
- Appendix D. Error Code Description
- Appendix E. Communication Matrix and Device Command
4.3 Wire Interconnecng Cable
You should use interconnecng cables to connect the main lane board and the sub lane board for
components communicaon.
Note
The right/middle pedestal contains an interconnecng cable, including one network cable (5.5 m)
and one 2-c
ore cable.
The picture displayed below describes the cable hole's posion on the pedestals.
Figure 4-3 Cable Hole of Interconnecng Cable
If the slong posion is at the middle of the pedestal, you can wire the cable through the
pedes
tal, and the side cable hole. For details about the wiring instrucons, see the picture below:
DS-K3Y411X Series Flap Barrier Quick Start Guide
14