Quick Start Guide
Table Of Contents
- Legal Information
- Regulatory Information
- Safety Instruction
- Available Models
- Chapter 1 Overview
- Chapter 2 System Wiring
- Chapter 3 Installation
- Chapter 4 General Wiring
- 4.1 Components Introduction
- 4.2 Wiring Electric Supply
- 4.3 Wire Interconnecting Cable
- 4.4 Face Recognition Terminal Power Supply Wiring (Optional)
- 4.5 Terminal Description
- 4.5.1 UART Related Terminal and Position
- 4.5.2 Main Control Board Terminal Description
- 4.5.3 Sub Control Board Terminal Description
- 4.5.4 BUS Terminal Description
- 4.5.5 Access Control Board Terminal Description
- 4.5.6 Access Control Board UART Description
- 4.5.7 RS-485 Wiring
- 4.5.8 RS-232 Wiring
- 4.5.9 Barrier Control Wiring
- 4.5.10 Alarm Output Wiring
- Chapter 5 Device Settings
- Chapter 6 Activation
- Appendix A. DIP Switch Description
- Appendix B. Event and Alarm Type
- Appendix C. Table of Audio Index Related Content
- Appendix D. Error Code Description
- Appendix E. Communication Matrix and Device Command
Figure 4-5 Connect Interconnecng Cable
4.4 Face Recognion Terminal Power Supply Wiring (Oponal)
If connect to face recognion terminals, the face recognion terminals of right pedestal and middle
pedestal (entrance) will power supplied by 12 V terminal on le side of the pedestal.
The f
ace recognion terminal of le pedestal and middle pedestal (exit) will power supplied by 12
V terminal of the power adaptor of the right pedestal. The sub lane control board will power
supplied by the power adaptor.
For details about the wiring, see the picture below:
DS-K3Y411X Series Flap Barrier Quick Start Guide
16